09830150841 call msg
Research & Development Activities

Our technical team is very active in new product development, quality control and keeping close relationship with our clients that moves the organization ahead. The active R&D areas are given below.

  • New product development
  • Quality control and analysis
  • Modification of existing design & properties towards better performance
  • Modification of existing design & properties w.r.t. customer feedback
  • Value engineering to evaluate cost of quality

In-house Quality Control Facilities

Incoming Raw Material Testing

Identification of Raw Rubber By Chemical Analysis, Testing of Incoming raw materials etc.

Process Control

Rheological Characteristics of Rubber Compound Individual Batch Weight Specific Gravity of Rubber Compound

Finished Product Testing

Instruments Test Parameters
  • Shore Hardness
  • Tensile Strength
  • Modulus of Elasticity
  • Elongation at Break
  • Accelerated Air Ageing at upto 400°C & 200°C
  • Muffle Furnace
    (Upto 1000°C)
  • Compression Set Apparatus for Cellular Material
  • Compression Set Apparatus for Noncellular Material
  • Swelling of Polymer in Various Solvents
  • Water Absorption by Weight and Volume Method
  • Abrasion Resistance
    (DIN Method)
  • Abrasion Resistance
    (BS 903 : Method B)
  • Ozone Resistance under Static & Dynamic Condition
    ( ≤200 pphm)
  • Load Deflection Test for
  • Non-Cellular Material
  • Upto 800 tonne & 03 Sq. Mtr Area
  • Load Deflection Test of Cellular Material
  • Specific Gravity of Vulcanised Material
Shore Hardness Meter Tensile Testing Machine
Air Oven & Muffle Furnace Glass Tube Ageing
Compression Set Apparatus for Non-Cellular Material Compression Set Apparatus for Cellular Material
Ozone Chamber Abrasion Resistance Tester (BS 903 : Method B)
  DIN Abrader

Design protection

The information set forth herein is furnished as a guide and provided based on the technical data as maintained internationally. Considering the continual upgradation of products the information given above may be changed without notice and we undertake no responsibility from the results deriving from their adoption. The structural design of the rubber pads (inner and outer) is registered and reserved by Metalastik Manufacturing Company Pvt. Ltd. under Indian Design Act 2000 and Indian Design Rule 2001. It can not be reproduced or transmitted in any form or by any means without written permission of the management of M/s Metalastik Mfg. Co. (P) Ltd, Kolkata.